HPE6-A45 Exhibits Practice Questions

Refer to the exhibits. Exhibit 1 Exhibit 2 The network administrator needs to set up BGP between the two company switches, Switch-1 and Switch-2. The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?

• AA. Set the update source for the neighbor to the local loopback interface on each switch.
• BB. Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.
• CC. Enable the multihop option for the neighbor on each of the switches.
• DD. Enable BGP on the interfaces that the switches use to reach each othe

Refer to the exhibits. Exhibit 1 Exhibit 2 Exhibit 1 shows the topology for the network. The network administrator sees the log entries shown in Exhibit2. Which type of failure is indicated?

• AA. A link between Switch-1 and Switch-2 went down. BFD detected the lost connectivity and behaved as expected.
• BB. Graceful restart helper was not enabled on Switvh-2, so BFD was unable to operate correctly, and the session was taken down.
• CC. A hardware issue caused a unidirectional link; BFD detected the issue at Layer 2 and prevented a broadcast storm.
• DD. BFD was set up incorrectly on Switch-2, so it caused Switch-2 to lose adjacency with Switch-1 rather than repair the session.

Refer to the exhibits. Exhibit 1 Exhibit 2 Exhibit 1 shows a portion of the BGP routing table when the BGP solution was first deployed. Exhibit 2 shows the same portion at the current time. What can explain the current state?

• AA. Due to changes in the private network, Switch-1 can no longer reach 192.168.2.1.
• BB. Switch-1 can no longer reach ISP 1 at 192.168.1.1.
• CC. Due to changes at ISP 1, Switch-1 now selects a different best route.
• DD. An administrator has applied a route map on Switch-1 that filters advertised route

Refer to the exhibits. Exhibit 1 Exhibit 2 Network administrators are alerted to high interface utilization on a switch by a management solution. They examine the utilization on the uplink interfaces several times an hour during problem times. The exhibit shows output typical of times of congestion. The administrators want to allocate bandwidth fairly and reduce congestion on the uplinks. What could help meet these requirements?

• AA. a per-queue rate limit on interfaces 1 and 2
• BB. an outbound rate limit on each edge port
• CC. a broadcast rate limit on each edge port
• DD. an outbound rate limit on interfaces 1 and 2