350-501 Router Practice Questions

Refer to the exhibit: In which way does router R1 operate differently than router R2?

• AA. R1 sends LSA type 2 only, while R2 sends type 1 and type 7 LSAs
• BB. R1 sends LSA types 1 and 2, while R2 sends type 1. 2. and 7 LSAs
• CC. R1 sends LSA type 2 only and R2 sends LSA type 1 only
• DD. R1 sends LSA types 5 and 7, while R2 sends type 1, 2, and 7 LSAs

Refer to the exhibit. A network engineer must configure an LDP neighborship between two newly installed routers that are located in two different offices. Router 1 is the core router in the network and it has already established OSPF adjacency with router 2. On router 1 and router 2. interface fa0/0 is configured for BFD. Which additional configuration must the engineer apply to the two devices to meet the requirement?

• AA. Router1(config)#int fa0/0 - Router1(config-if)#mpls ldp autoconfig Router2(config)#router ospf 1 - Router2(config-router)#mpls ip
• BB. Router1(config)#int fa0/0 - Router1(config-if)#mpls ip Router1(config-if)#mpls ldp discovery transport-address interface Router2(config)#int fa0/0 Router2(config- if)#mpls ip Router2(config-if)#mpls ldp discovery transport-address interface
• CC. Route1(config)#int fa0/0 - Router1(config-if)#mpls ldp autoconfigRouter1(config-if)#mpls ldp discovery interface Router2(config)#router ospf 1 Router2(config- router)#mpls ldp autoconfig Router2(config-if)#mpls ldp discovery interface
• DD. Router1(config)#int fa0/0 - Router1(config-if)#mpls ip - Router2(config)#router ospf 1 Router2(config-router)#mpls ldp autoconfig